How to Add Layer 2 Switch in GNS3 | Cisco L2 Switch IOS vIOS-L2 | SYSNETTECH Solutions

How to Add Layer 2 Switch in GNS3 | Cisco L2 Switch IOS vIOS-L2 | SYSNETTECH Solutions


How to Add Layer 2 Switch in GNS3 | Cisco Layer 2 Switch IOS vIOS-L2 | SYSNETTECH Solutions Subscribe to our YouTube channel for more videos on Cisco Switching with GNS3!

42 thoughts on “How to Add Layer 2 Switch in GNS3 | Cisco L2 Switch IOS vIOS-L2 | SYSNETTECH Solutions

  1. This is a nice job. Thank you!
    I have 2 questions.
    When I add 24 ports in the Network-> Adapters section of the switch then I see ports 0/0-3, 1/0-3, 2/0-3…. Is there a way to have ports 0/1-24?
    In the same section Network->Type I can only see GigaEthernet and Ethernet. Is there a choice for Fast Ethernet?

  2. Hi, thx for the video.
    But I have a problem after installing Vios-2 which is when I run the MSW then I issue for example #show int g0/0 then in the output it say unknown Media Type which in the result of that SW can't do the negotiation for speed and duplex and reads all the interfaces as shared type (Like a hub interface) in the output of # show spanning-tree .
    I googled a lot about it but I couldn't find a solution to that, I also used different versions of GNS3 like 1.5.3 and 2 but the same issue.
    if you could guide me through that it would be great.

  3. The switch keeps on rebooting for me; https://cdn.discordapp.com/attachments/279751317122056193/348396869572886528/Switch_load_issue.docx

  4. When you try to add a layer 2 switch via an appliance from GNS3 you get the KVM not supported issue. Adding it this way thru QEMU under preferences was mindless. Thanks for the easy factor. Routing newbie and I appreciate the good videos.

  5. Hello , Thanks for this easy step switch build on GNS3 , I just have a doubt when writing the configuration after the reboot of the switch it goes back to default configuration as if I did nothing any solution please for this ?

  6. Hey bro, Can you help me?
    I have install IOU L2 SW in GNS3 2.0.3, I can not ping through IOU sw.
    Example:
    Simple topology => Router – IOU (L2) SW – Router:
    + I config interface in the same subnet but I can not ping each router another, but I replace the IOU sw by ethernet SW in GNS , each router can ping with another.
    + I have try many version of L2 IOS but it not work and config no ip routing, no shut interface,no shut interface vlan 1 but is no work to.

    Tks you!

  7. How to Add Layer 2 Switch in GNS3 | Cisco Layer 2 Switch IOS vIOS-L2 | SYSNETTECH Solutions ► Article ► https://goo.gl/MJ3AGS

    ✅ S U B S C R I B E ► http://goo.gl/8d0iG9

  8. I done all the things as you say but.that layer 2 switch was not boot…..its shows 127.0.0.0 retrying…but it wasn't working why?

  9. Hello There, I followed your video and it installed OK BUT the IOS doesn't load when I telnet in can you assist I am using GNS3 2.1.21

Leave a Reply

Your email address will not be published. Required fields are marked *